Specification for wire harness cutting and wiring

1. Mainly for the operation of the sensor harness, the main harness must not be cut and re-wired
2. When the wire harness is too short and needs to be re-wired, the cut wire harness must not be cut evenly. The difference between the two wire harness connectors should be about 30mm. The conductor should not be broken when crimping, and the cross-section of the contact should meet the quality requirements. After wiring, wrap with insulating tape. It is required that the insulating tape is wrapped completely, the thickness of the tape wrapped is appropriate, safe, reliable and beautiful.
3. When the connectors cannot be plugged together and the terminals need to be crimped again, the terminals should be pressed tightly on the conductor and the insulating layer respectively, the conductor should not be broken, and the insulating layer should not be pressed into the crimping part of the conductor. After crimping Wire conductors must not interfere with insertion. The cross-section of the crimping terminal and wire crimping place should meet the quality requirements. The connection between the terminal and the wire should be firm, and should not be damaged or disengaged under the specified tension, and the tension value should be less than the regulations in Attached Table 1.
4. When wiring, the diameter and color of the selected wire and the butt wire should be uniform. If it cannot be agreed under special circumstances, it must be ensured that the same type of vehicle must be connected at the same position.